CURT 55326 Voertuig-Side Custom 4-Pin Trailer Kabelboom, Past Select Ford Crown Victoria, Ford Mustang, Mercury Grand Marquis, Zwart

Brand:CURT

3.3/5

66.01

Indien uw voertuig niet voorzien is van bekabeling voor het trekken van een aanhanger, is CURT maatwerkbekabeling de ideale oplossing. Een op maat gemaakte kabelboom - ook wel een T-connector genoemd - is een eenvoudig, plug-and-play elektrisch apparaat dat wordt aangesloten op het elektrische systeem van uw auto en zorgt voor een standaard, universele aansluiting voor de bedrading van de aanhangwagen. Dit wordt gedaan met behulp van twee of meer voertuigspecifieke, OEM-compatibele connectoren die in het achterlicht worden gestoken, waardoor knippen, splitsen en solderen tijdens de installatie niet meer nodig is. Op maat gemaakte kabelbomen zijn voertuigspecifiek gemaakt en hoewel ze niet voor alle voertuigen beschikbaar zijn, bieden ze wel een van de snelste, gemakkelijkste en veiligste manieren om een ​​voertuig te bedraden om te slepen. Deze specifieke plug-in kabelboom biedt een 4-wegs platte connectoraansluiting en is ontworpen als een aangepaste kabelboom voor bepaalde jaren van de Ford Crown Victoria, Ford Mustang en Mercury Grand Marquis (om de compatibiliteit van uw voertuig te controleren, zie toepassingsinformatie) . Het wordt geleverd met alle benodigde bedradingscomponenten om een ​​betrouwbare aansluiting voor de bedrading van de aanhanger tot stand te brengen, evenals een stofkap om de connector schoon te houden wanneer deze niet in gebruik is. Je hebt een beeld in gedachten van je volgende bestemming -- misschien is het de aanlegsteiger van je favoriete visstek, misschien is het een camping die uitkijkt op een van de meesterwerken van de natuur, of misschien is het de volgende grote werklocatie. Om dat beeld werkelijkheid te laten worden, is echter meer nodig dan alleen dagdromen. Er is een solide verbinding en de juiste hoeveelheid stroom voor nodig. CURT-bedrading op maat is gemaakt met de meest geavanceerde technologie in de branche en is ontworpen om gemakkelijk te installeren, waardoor u een langdurige elektrische verbinding krijgt voor uw trekhaakopstelling.

STOFKAP. Om langdurig gebruik en weersbestendigheid te bevorderen, wordt deze 4-polige kabelboom voor aanhangerverlichting geleverd met een rubberen stofkap. Hij past gemakkelijk op de 4-weg platte connector wanneer hij niet in gebruik is, en beschermt hem tegen de elementen buitenshuis. GEMAKKELIJKE GREEP. Het aansluiten van uw aanhangwagenbedrading en aanhangwagenverlichting is eenvoudig dankzij het ergonomische ontwerp van dit voertuigstopcontact. Het heeft lipjes aan de boven- en onderkant voor een betere grip bij het aansluiten op uw aanhanger of loskoppelen. VOERTUIGSPECIFIEK. Deze aftermarket-kabelboom voor voertuig-aanhangwagen is ontworpen voor geselecteerde jaren van de Ford Crown Victoria, Ford Mustang en Mercury Grand Marquis. STANDAARD CONNECTOR. Deze plug-in 4-voudige aanhangerbedrading kan worden gebruikt voor het aansluiten van aanhangerachterlichten, remlichten en richtingaanwijzers. 4-weg bedrading voor aanhangwagenverlichting is populair op een verscheidenheid aan aanhangwagens, waardoor veelzijdige trekmogelijkheden voor uw voertuig worden toegevoegd. MAKKELIJK TE INSTALLEREN. Niet snijden! Geen splitsen! Deze kabelboomset voor een aanhangwagen kan worden aangesloten op de bestaande fabrieksbedrading van uw voertuig en is uitgerust met een standaard 4-pins aanhangwagenbedradingsconnector aan de achterkant voor het aansluiten en trekken van een aanhangwagen.
Brand CURT
Brand ‎CURT
Country of Origin ‎USA
Customer Reviews 4.2 4.2 out of 5 stars 44 ratings 4.2 out of 5 stars
Is Discontinued By Manufacturer ‎No
Item Dimensions LxWxH 9 x 4 x 2 inches
Item model number ‎55326
Item Weight 0.49 Pounds
Item Weight ‎7.8 ounces
Manufacturer ‎Curt Manufacturing
Manufacturer Part Number ‎55326
Material Rubber
Model ‎Custom Wiring
OEM Part Number ‎55326
Product Dimensions ‎9 x 4 x 2 inches

3.3

9 Review
5 Star
60
4 Star
20
3 Star
10
2 Star
0
1 Star
10

Schrijf je beoordeling

Uw e-mail wordt niet gepubliceerd. Alle verplichte velden zijn gemarkeerd met*

Scritto da: Romy
Easy to install, but the finished install is jank
Super easy to install, instructions are included but you basically just piggyback this into your rear lights. I think it took like 10 minutes on my 97 Crown Vic. It helps to have some sort of trim removal tool to pop off the plastic clips Ford used to hold the trunk trim up with. It works fine, didn't have to rewire it like some other folks said. Biggest issue I have (which is why it's 4 stars) is that it stays in your trunk until you need it. Like, loose in the trunk. The instructions say something with the gist of 'just sort of tuck it up out of the way someplace.' When you want to use it, you pull it out of the trunk, hook it up to the trailer, and just kind of close the trunk lid on the wires. It's not like the fit and finish on a mid-90s Ford makes this problematic (the wires don't get pinched at all), but it's just jank. They could have routed it through a body plug or something similar (albeit the wires are too short to go through any of the stock body plugs). I'll eventually properly mount this outside the car, but it's going to be a PITA since the connectors will have to be depinned, a hole will need to be drilled, and I'll need to route it all through a grommet that fits said hole. Totally doable, but it's going to take more than 10 minutes.
Scritto da: WEH
Works great!
Fits perfect on my 1995 mustang.
Scritto da: John T. Ertz
Easy to plug in, but was wired wrong.
Very simple to install as stated in the instructions, but as soon as I tested my lights my left signal started flashing fast as though a bulb was burned out, but it was also flashing the side marker light. Disconnected harness and all returned to normal. Broke out test lamp and found that the harness wires from this unit had been improperly placed. In the female connector that plugs to the vehicle wire harness, the Yellow (signal) wire is in the top right, with the Brown (marker lamp) wire in the bottom right. However on the male plug that goes to the taillight and sidemarker, the Yellow and Brown wires are reversed so that the Stop/Turn wire is trying to feed the side marker and the Brown side marker wire is trying to feed the Stop and Turn function. Might want to check that quality control at your Mexican plant and make sure the assembler isn't color blind...
Scritto da: IntoxicatedRedneck
Works
Arrived this evening, I was nervous to open anything from the mail at this point. However, I needed to go pick up my S-10, so I opened it up and found out the harness was real easy to install. I put this in my 96 Mercury Grand Marquis, it basically just snaps into the back of the tail light plugs on the both sides. Takes a minute, hooked up my car trailer, everything worked like it should. Picked up my truck, came back home, everything still works. Its a gud buy.
Scritto da: Yooper-in-gb
Curt 55326 wire harness
This device does not fit a 2004 Mercury Grand Marquis LS as stated on the Amazon parts selector. It only works up to 1997. Curt harness #58044 is for later models and must be spliced in. This(55326) harness just plugs in and looks like a great way to put on a trailer plug. I am sure it works great on the correct model cars. Note for Curt Mfg. - Amazon does NOT download directly from Curt what parts fit each model, so check the Curt site first for compatibility.
Scritto da: joshua
Nice
Work perfectly for mustang 94 convertible V6
Scritto da: Louis c.Brown jr.
Four Stars
thank u
Scritto da: David Plowman
Five Stars
I have not used it yet but think it well work
Scritto da: Amazon Customer
Great price
Quick and easy install

Gerelateerde producten

Ontdek ons ​​internationale netwerk

We verzenden naar 28 landen, meer dan 200.000 producten. Blijf op de hoogte, schrijf je in voor de nieuwsbrief.

Array