VEVOR Air Jack, 3 Ton Triple Bag Air Jack, Air Bag Jack Lift tot 15,75 inch, 3-5S Snel Lifting Air Bag Jack voor auto's met korte steel (beige) 3 ton korte steel

Brand:VEVOR

3.5/5

267.44

Brede toepassing: de autolift met snelle krik is perfect voor de situatie waarin een enkel wiel moet worden opgetild op zacht terrein, water op zand of modderige wegen voor gezinsauto's, minibusjes, SUV's en terreinwagens. Ruimtebesparend ontwerp: het ontwerp van de handgreep past zich aan de vorm van de hand aan, zodat u de krik volledig kunt bedienen wanneer u hem gebruikt. En de hele structuur is compact en gemakkelijk op te bergen. Je kunt hem dus gemakkelijk mee naar buiten nemen. Veilig gebruik: houd eerst de rode klep gesloten, open de groene klep en voer de perslucht in; bij het opblazen tot de hoogte, draai de groene klep dicht. Open na gebruik het rode ventiel om de lucht te laten ontsnappen. De veiligheidsklep in het midden zorgt ervoor dat het geïnjecteerde gas niet overmatig is om de veiligheid van het gebruiksproces te waarborgen. Zware constructie: onze pneumatische krik is gebouwd met hoogwaardig staal dat het hele lichaam stevig en duurzaam maakt. Het gepoedercoate stalen frame en het rubber passen bij elkaar om de impact te verminderen. Sterk afgedichte airbags zullen niet lekken of bekrast raken. Een groter gestrest gebied past op een zachte en gemakkelijk instortende plek. Arbeidsbesparende krik: capaciteit pneumatische krik: 6600 lbs/3T. Minimale hoogte: 5,3/135 mm. Maximale hoogte: 15,75/400 mm. Het duurt slechts 5 seconden om op te tillen. Werktemperatuur: -60 ℃ ~ 50 ℃. Luchtinlaat: G1/4. Onze driedubbele krik is de makkelijkste en snelste manier om de auto te laten heffen.

Geen eenheden beschikbaar
Brede toepassing: de autolift met snelle krik is perfect voor de situatie waarin een enkel wiel moet worden opgetild op zacht terrein, water op zand of modderige wegen voor gezinsauto's, minibusjes, SUV's en terreinwagens. Ruimtebesparend ontwerp: het ontwerp van de handgreep past zich aan de vorm van de hand aan, zodat u de krik volledig kunt bedienen wanneer u hem gebruikt. En de hele structuur is compact en gemakkelijk op te bergen. Je kunt hem dus gemakkelijk mee naar buiten nemen. Veilig gebruik: houd eerst de rode klep gesloten, open de groene klep en voer de perslucht in; bij het opblazen tot de hoogte, draai de groene klep dicht. Open na gebruik het rode ventiel om de lucht te laten ontsnappen. De veiligheidsklep in het midden zorgt ervoor dat het geïnjecteerde gas niet overmatig is om de veiligheid van het gebruiksproces te waarborgen. Zware constructie: onze pneumatische krik is gebouwd met hoogwaardig staal dat het hele lichaam stevig en duurzaam maakt. Het gepoedercoate stalen frame en het rubber passen bij elkaar om de impact te verminderen. Sterk afgedichte airbags zullen niet lekken of bekrast raken. Een groter gestrest gebied past op een zachte en gemakkelijk instortende plek. Arbeidsbesparende krik: capaciteit pneumatische krik: 6600 lbs/3T. Minimale hoogte: 5,3/135 mm. Maximale hoogte: 15,75/400 mm. Het duurt slechts 5 seconden om op te tillen. Werktemperatuur: -60 ℃ ~ 50 ℃. Luchtinlaat: G1/4. Onze driedubbele krik is de makkelijkste en snelste manier om de auto te laten heffen.
Brand VEVOR
Brand ‎VEVOR
Color black
Color ‎black
Country of Origin ‎China
Customer Reviews 4.4 4.4 out of 5 stars 126 ratings 4.4 out of 5 stars
Item model number ‎White Triple Bag Jack
Item Weight ‎19.5 Kilograms
Item Weight ‎42.9 pounds
Load Capacity 3 tons
Load Capacity ‎3 tons
Manufacturer ‎VEVOR
Manufacturer Part Number ‎Long Handle White Air Jack
Material Alloy Steel
Material ‎Alloy Steel
Minimum Height ‎400 Millimeters
Model ‎Triple Bag Car Jack
Package Dimensions ‎20.1 x 16.5 x 7.1 inches
Style ‎Short Handle
Vehicle Service Type Car
Vehicle Service Type ‎Car

3.5

12 Review
5 Star
72
4 Star
11
3 Star
10
2 Star
0
1 Star
6

Schrijf je beoordeling

Uw e-mail wordt niet gepubliceerd. Alle verplichte velden zijn gemarkeerd met*

Scritto da: Richie
It works, it's fast ... but
This air jack does work and it is fast for my needs: a Fiat 500 Pop, a Fiat 500 Abarth and a Nissan Sentra. Both Fiats have lowered suspension and this jack is low enough to get where it needs to go. Having said that, there are no assembly instructions at all. There is a sheet of paper with icons and a short how to use but none for assembly. However, It is not difficult to figure out. You will need a 10mm wrench or socket with an extension and a Phillips head screwdriver to attatch the 6 nuts and bolts for handles and control block (sorry about the oil marks on the instruction sheet, that's from having to use a 6x1.0mm die to fix the thread on one of the bolts!) You will need scissors or cutter and 13mm wrench to attatch the hose on the Control Block as well. The hose supplied is longer than necessary and, in my case, when attatched as is, the hose kinked at one of the bends, shortening the hose removed the kink. My jack was supplied with a 3/8 inch air hose fitting. My compressor and hose uses a 1/4 inch fitting (as do most home DIY). I had to remove the 3/8 inch (male) hose fitting on the control block and install a 1/4 inch fitting.
Scritto da: J Valenzuela
For a car yes but for SUV: NO
I had to revise my review to reveal more in addition regarding poor welding quality perhaps the whole assembly line's aim is just box and ship it. Even the screws were at the cheapest level I couldn't use so I changed them all while I properly apply the right torque. I also wanted to add that in order to take a wheel off a Mazda CX-5 (jacked up from the side) it needs maybe 4" additional. Having said that for the solution of a 4x4 wood block is enough while still embrace the speed of it.
Scritto da: Eric P
Where have you been all my life!
I am happy with this jack. I own a towing company. Having a good jack is crucial. Often on soft ground conventional jacks are impractical. My service truck has on board air so this is a perfect fit.
Scritto da: T. P.
Great tool
This jack is a great addition to my tools in my shop.
Scritto da: CARL KOLBERG
Very easy to use and works great
great product and works great
Scritto da: eneidamaria
Retorque all the Allen screws before using.
The best part about this jack is NOT having to pump the handle or twisting the handle to lower the jack. I lifted the left side of a Ford Explorer (~4,000 lbs) easily with about 60 PSI. Unlike a hydraulic jack, the lift was smooth and quick. Having a tow handle makes positioning the jack a snap. The air line connection is the same as all my air tools. The bronze filter fitting on the exhaust side is a thoughtful idea so the user does not get an air blast when lowering the jack. Being able to slowly control the lowering is a major improvement over my hydraulic floor jacks. I always check torque on the fasteners before using the device. A couple of the 16 screws were less than finger tight. I torqued all of them to 150 inch pounds, 4 and 5 mm Allens. I also cut a 4X4 block to sit over the rubber cap for some extra height. Probably won't use it for my Ford Edge. Overall, very pleased with this device.
Scritto da: P. MCGAFFEY
Works for sports cars.
Getting too old to pump up an old jack, so I thought i would give this thing a try. It worked pretty well and very quickly on my low sports car. I does not like working at angles though. It sticks. After watching a YouTube video, I opened the airbag up to lubricate the steel sleeves inside. I found that they were already coated with lightweight gray grease. I tried it on my SUV to change brake pads. It was a little sketchy to stack up blocks of wood to get the extra height needed to get the wheels off the ground. Had to do it in several steps which wasted a lot of time. Next time, I will just use my standard floor jack for that job.
Scritto da: ron sprugasci
Nice easy to use
No dislike used on my car lift to take tires off
Scritto da: Amazon Customer
Very nice product
Easy to use fast elevation it’s look like a good product, we will see in the future
Scritto da: Super
Super fiabilité
Stabilité et fiabilité j’adore
Scritto da: Amazon Customer
WOW just WOW!!!
got this for my dad as a Father's day gift. it works awesome! My Dad's Sorento 2020, my Chrysler 300S 2016 and my wife Elantra 2019 all went and got tire changes with this with no issue. Yes do keep it as straight as possible, if not it kinda sticks, but it's understandable. Very very happy with the purchase. I did have to put a reg US air inlet on it which i already had.
Scritto da: FDIMIKE
It is a bit wobbly.
Whatever is inside of the air bags used to keep the bags straight inline when raising and lowering is a very loose fit, causing the jack to tip one way or the other as it goes up, even on a concrete floor. It causes the jack to jerk when going up and actually stop altogether when trying to lower.

Gerelateerde producten

hot
Esco Yak 2-traps luchtblaaskrik, 2,2 ton
3.4/5

€ 978.27

Esco Yak 2-traps luchtblaaskrik, 2,2 ton
3.4/5

€ 978.27

hot
OTC LDJA2 aluminium racekrik - 2 ton
2.6/5

€ 983.96

OTC LDJA2 aluminium racekrik - 2 ton
2.6/5

€ 983.96

Ontdek ons ​​internationale netwerk

We verzenden naar 28 landen, meer dan 200.000 producten. Blijf op de hoogte, schrijf je in voor de nieuwsbrief.

Array